Setup and Menus User Manual

Commissioning
Fluid Components Intl
Document 06EN003327 Rev. -
61 FlexCor
™ Model CMF Series
Menu detail
7.5.4 Sensor
characteristics
When the SENSORPROM
®
memory unit is installed only the parameters correction factor,
density offset, fraction offset and table slope can be changed.
If you wish to change the mass flow measurement a percentage shift can be set under the menu
option correction factor. The change affects all flow-related values.
If you wish to change the density measurement a percentage shift can be set under the menu option
density factor.
If an offset needs to be added to the density measurement this is done with density offset.
If the fraction flowmeter function is used it is possible to customize the function in accordance with
the following equation:
Fraction = Ax + B, where
A = Table slope
B = Fraction offset
x = Measured fraction
Correction factors