User Manual
Fluance RT82, RT83, RT84, RT85 User Manual
14
Maintenance
Replacing the Stylus
Use the chart below to ensure you replace your stylus with the correct model.
Replacement stylus and instructions are available at www.uance.com/turntables
Cartridge Connections Turntable Cartridge Specications
Model Cartridge Stylus
RT82 OM 10 Stylus 10 E
RT83 2M Red Stylus 2M Red
RT84 / RT85 2M Blue Stylus 2M Blue
Wire Channel
White Left (+)
Blue Left (-)
Red Right (+)
Green Right (-)
Supported Cartridge
Weight
5.0 to 7.5 grams
Effective Tonearm Mass
RT82 21.78 grams
RT83
27.5 grams
RT84
RT85
Overhang 19.2 mm
Effective Tonearm Length 224 mm
Headshell Cartridge Mount Half-inch Mount
Fluance Headshell Weight 9 grams
Replacing the Rubber Belt
1. With the platter installed remove the defective rubber belt from the motor pulley and platter.
2. Wrap the new rubber belt around the platter being careful to not overstretch the belt.
Ensure it is not twisted.
3. Lift the rubber belt and place it over the motor pulley.
4. Rotate the turntable several times to ensure the rubber belt is secure and not twisted.
Upgrading the Cartridge
The turntable supports the option of upgrading the cartridge. A complete cartridge
replacement guide and video are available at www.uance.com/resources
There is also a Cartridge Alignment Protractor at the end of the manual for your convenience.
OM 10 2MRED/2MBLUE