FX QUICK & EASY MAT SOLAR HEATER VER.
A. SAFETY INSTRUCTIONS READ ALL WARNINGS BELOW. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL INJURY OR DEATH. Carefully read and adhere to all CAUTION and NOTE notices located throughout this manual. Failure to comply with these instructions for use, can cause serious injury, death, or damage to the unit. DO NOT allow children to operate this product. Always turn the filter system to a setting that dose not allow flow to the pool return when installing or working on the solar heater.
C. HOW IT WORKS When properly installed, the solar bag will be connected to your filter and your pool by two hose connections: One hose will feed cold, filtered pool water from your pump into one port of the solar bag. The other hose will feed sun warmed water from the other port of the solar bag to your pool via the pool return inlet in your pool. As cold water is fed into the solar bag, it travels through the solar coils where it is heated by the sun before it is delivered back into your swimming pool. D.
I. PARTS LIST / REFERENCE Primary Components: Intex Special Adapter with O-ring(2)& Flat Gasket(2) Note: Some parts may be pre-installed at the factory. Parts not shown to scale. J. INSTALLATION INSTRUCTIONS 1.Heater – Filter – Pool Layout The system layouts below will help you install the solar bag(s) to your above ground pool.
2. Heater - Pool Connections These instructions assume that the pool and filter system are already assembled and there is a hose attached to the pool return (pool water inlet). Place the solar heater in a location where it will receive the greatest amount of sunshine and at least 9.8ft(3m) away from pool. 1) Heater - Filter Pump Connection a. Turn off filter pump. b. Block water flow at both the pool return inlet and the filter pump outlet to prevent water from flowing through the hoses. c.
K. INITIAL OPERATION Once the solar heater has been assembled and the hoses are connected to the filter pump and pool return, unblock the flow of water into the pool return hose and turn on the pump and filter system. Bubbles will shoot out of the return nozzle into the pool initially while air is pushed out of the solar heater. If this persists for longer than 2 or 3 minutes, check for and repair any leaks in the hoses or connections. L.
