Instructions / Assembly

A. Safety Warnings
Read all Warnings and Cautions noted below. Failure to do so could result in serious or fatal
injury.
Prior to installation of this unit, carefully read and adhere to all CAUTION, ATTENTION, and
ADVICE notices located throughout this manual. Failure to comply with these instructions
can cause serious injury, death, or damage to the unit.
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED CAN RESULT
IN SERIOUS INJURY OR DEATH. Do not block pump suction at the pump or in the pool as
this can cause severe injury or death.
Electrical wiring MUST be installed by trained professional and adhere to local code and
regulations.
Avoid electric shock. DO NOT USE power extension cords.
Connect ONLY to a Ground-Fault Circuit Interrupter (GFCI) power outlet. Consult a
qualified professional electrician for safe and proper installation of a qualified electrical
outlet.
Incorrectly installed equipment may fail, causing severe injuries or damage to the
pump-filter system.
Never submerge the filter and/or pump in water.
Never place the pump or filter in your pool.
Trapped air in the pump-filter system may cause the TANK COVER to be blown off which
can result in death, serious injury, or damage to the pump-filter system. Ensure all air is out
of system before operating.
Never change the 7 Position Multi-Port Valve while the system is operating.
ALWAYS unplug the system before changing the control valve.
Install this product with sufficient safety margin from the pool to prevent children from using
the system to access the pool.
Never PLUG or UNPLUG this unit from an electrical source while standing in water.
NEVER service this unit with electrical power cord connected.
DO NOT operate the system while the pool is being used.
KEEP CHILDREN AWAY from all electrical equipment.
NEVER ALLOW CHILDREN TO OPERATE THIS EQUIPMENT.
The Pool Owner should always exercise caution and common sense when utilizing their
swimming pool and operating equipment.
B. General Information
This manual provides information relating to the installation, utilization and maintenance of our
filtration system. We recommend that you read this manual in its entirety and keep it for future
reference.
The pump included with the filtration system is a horizontal, self-priming centrifugal pump. For
the pump to function correctly, the water temperature must not exceed 35℃/95℉. The materials
used in the pump have undergone stringent hydraulic testing and electrical inspections.
The filter tank included in the filtration system consists of high-grade polypropylene (PP). It is
manufactured as a single unit (absolutely corrosion resistant and resistant to commercially avail-
able swimming pool chemicals). (Prerequisite: Compliance with the standard recommended


















Page 2