Owners manual

53622FLT - 2 1/2” UNIVERSAL CROSSPIPE
53623FLT - 3” UNIVERSAL CROSSPIPE
53630FLT - 2 1/2” UNIVERSAL CROSSPIPE w/ cutouts
53631FLT - 3” UNIVERSAL CROSSPIPE w/ cutouts
53622FLT shown 53630FLT shown
NOTE: IT IS THE INTENT AND DESIRE OF THE MANUFACTURER THAT THIS PRODUCT BE USED IN COMPLIANCE OF ALL
LOCAL, STATE, AND FEDERAL EMISSIONS LAWS AND REQUIREMENTS. Please refer to the Limitation of Liability.
As a result of restricted room available in some engine compartments, you may experience a close fit to some body and chassis
components. This is a normal condition. If this is the first time installing a set of headers, it may be timing consuming. While not
complex, stick with it. As soon as you start your engine, the reward of the additional horsepower and performance will be well worth
your efforts. Proper installation and periodic maintenance will result in the maximum performance and life of your FLOWTECH™
headers.
READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING:
For the ease of installation, your vehicle must be raised a minimum of 24".
WARNING: Should you decide to install any exhaust product yourself, be warned that the original equipment jack that came with the
vehicle is intended for emergency use only. The use of a frame jack, in conjunction with a floor jack, as the main support
is highly recommended to minimize the accidental dropping of a vehicle while the installation proceeds. Never go under
a vehicle that is supported by only a bumper jack!
NOTE: Some cutting and welding tools will be required for this installation.
Flowtech® recommends that all joints be welded for support and a leakproof installation.