User guide

RevA MN300282 13of34
CONFIGURATION(cont.) StepFive
HowtosetaLOWALARM

Before starting, measure the distance from the bottom of the
tanktotheLowAlarmposition(ON)inthetank.
1. In TOP‐LEVEL MENU mode, select RELAY1, RELAY2 or
RELAY3.
2. SelectALARM.
3. SelectLOW.
4. Using the UP and DOWN buttons, set the LOW (ON) set
pointfortherelay.
5. To enter the value, press and hold SELECT for 2 seconds
andrelease.SAVEDwilldisplay.
6. SelectHYSTERtosettheHysteresis.
a. Hysteresis is the distance away from the original ON
settingwheretheAlarmwillturnOFF.
7. UsingtheUPandDOWNbuttons,settheHYSTER(OFF)set
pointfortherelay.
8. To enter the value, press and hold SELECT for 2 seconds
andrelease.SAVEDwilldisplay.
9. SelectEXITtoreturntoTOP‐LEVELMENU.
Note:Thehysteresis(HYSTER)settingcanbeusedtoeliminatechatteringoftherelay.
Note:Tospeedupthescrollingofthevaluesonthedisplay,holddowntheSELECTbuttonwhileholdingdown
theUPorDOWNbuttons.

