Owner manual

6
Entertheappropriatetanklevelsetpointsforyourapplication.
 Units. Display measurements in inches
orcentimeters.
 Sensor Height. Distance measured from
the bottom of the empty tank to the
bottomofthe transducer.Underfactory
configuration,thisbecomesthe4mAset
point.
 Fill Height.
Distance measured from the
bottom of the empty tank to the
maximum fill height within  the tank.
Under factory configuration, this
becomesthe20mAsetpoint.
TankLevelSettings
The options on the right of the WebCal screen to finalize the
configuration.
 WritetoUnit.SendyourconfigurationintoEchoSonic®II.
 Wiring Diagram. Open PDF wiring schematic of your
configuration.
 Advanced. Configure advanced settings. Read the section
belowonadvancedsettingoptions
 Factory Config.
 Return EchoSonic® II to the original factory
configuration.
 ClearScreen.Clearsthescreenofconfigurationsettings.
 Config File. Name, save, open or print your configuration for
lateruse.


FinalizeSettings

