Owner manual

5

Usingthedrop‐downmenusontheleftoftheWebCalscreen set
the configuration for your application requirements. When a 
selection does not apply to your application, “Not Applicable”
willappearinthedrop‐down. Makesurealldrop‐downs are set
appropriately for your application before moving to the
 Tank
Levelsection.
 Loop Fail Safe. Use this setting to choose the output  level
shouldthesensornotreceiveanecho.
 Output at Empty. Use this setting to change the 4‐20 mA
settingfromitsdefault.
 StartupCondition.Duringthe15‐20secondsduringwhich
the
EchoSonic
®
IIstartsup,thisdescribesthelevelatwhichitwill
beginsearchingforthecontentsofthetank.
NOTE: If you would like to start over, click the Clear Screen
buttonontheright.


A New feature of WebCal 6.0 is the ability to configure the sensor in
volumetric units
(Gallons or Liters) or in the existing Distance (Height of Liquid) units (inches, cm, feet or
meters).TochangetheactualunitsortochangefromDistancetoVolume,presstheTanks 
buttonloca tednearthecenterofthewindow.
ShapeSelectionWindow: DimensionalEntryWindow:
This window
 will show the
different options for tank
shapesavailableinWebCal.




Enter the dimensional
information for the
tank.You must enter
allofthefieldsshown.
 SensorHeight:
 FillHeight:
 RiserHeight:
 TankHeight:
 Diameter:
Note: Not all of the
fields apply for every
tankconfiguration.
