Owner manual

3
ConfiguringtheEchoSonic®II
Configuration of your sensor should be performed prior to mounting, since it requires
connectiontoyourPC.

Step1:InstalltheWebCalSoftware
Download WebCal from www.flowline.com
 onto a PC with the following minimum
specifications:
Windows
®
2000/XP/Vista/7/8,10MBstoragespace,256MBRAM,1USB2.0port
Double‐click the WebCal icon to install before proceeding to Step 2. You must have an
activeInternetconnectiontoinstallWebCal,asitwillautomaticallyverifydriverupdates.
Step2:ConnecttheUSBFob
NOTE:Donot
connecttheFobuntilafteryou’veinstalledWebCal.
The sensor communicates to its configuration software through the USB Fob. Prior to
connectingtheFob,ensurethatallexternalpowerisdisconnected fromtheEchoSonic®II
as power is provided through the PC’s USB 2.0 port. Do not use a cable connecting
 the
sensortotheFobanylongerthan15feet.

1) Connect the red, green, white, and black wires  from the EchoSonic® II to the
correspondingcoloredterminalsontheFob(asshowninthediagram). 
2) Tightentheterminalscrewswithaslottedscrewdriver.
3) PlugtheFobinto
yourPC’sUSBport.


