Owner manual

2
WelcometotheEchoSonic®IIQuickStart
The EchoSonic® II quick start is meant to show some of the more common setup
solutions to getting the EchoSonic® II up and running quickly.If you run into an is sue
thatisnotaddressedhereorwishtoinstallorsetupwith
anon‐standardconfiguration,
please address the EchoSonic® II Manual or refer to the Flowline website at
www.flowline.com
.
WeDoYourLevelBest
ThankyouforpurchasingFlowline’sEchoSonic®II.Thisgeneralpurposeultrasonicsensor 
provides non‐contact detection upto 9. 8’ (3m) po wered bythe 4‐20mA loop.This quick
start includes everything you’ll need to get the sensor up and running.For complete
information,pleaserefer
toEchoSonic®IIdocumentationlocatedatwww.flowline.com.
Components
Dependingonhowthesensormodelthatwasshipped,youshouldhavetheEchoSonic®II
andViton®gasket which arerequiredto installtheEchoSonic® II.Some modelswill have
the USB® Key Fob (LI99‐1001) included with the EchoSonic® II.Other will require the
separate purchase of the
 Fob.A LI99‐1001 Fob is required to interface to WebCal® and
configurethesensor.


EchoSonic®II
LU27‐40,LU27‐41
LU27‐50,LU27‐51
Viton®gasket(1”)
P/N:200128
USB®KeyFob
P/N:LI99‐1001

