Owner's manual

27 AUG 08 PRELIMINARY MANUAL 47 of 57
Rev 1_3 Commander LI90 Series
o To change a value, first press the Enter key
• The value will be highlighted
• Use the 10-digit keypad to enter the desired value
• I.e. for 123.4, press the following keys: <F1>, <F2>, <F3>, <. >,
<F4>,
• Press Enter when completed to store this value to memory
• Follow the sequence above:
• 1. Press Enter to begin
• 2. Press F1 for number 1
• 3. Press F2 for number 2
• 4. Press F3 for number 3
• 5. Press ▼ for “.”
• 6. Press F4 for number 4
• 7. Press Enter to save setting
• The screen cannot change until a value is stored in memory.
o Use the Next soft key to advance to the next setting
o Use the Back soft key to return to the previous setting
o Option – Relays 5 and 6 can be used as a Duplex / Alternation function
o Select Config. Relay #5 and #6 to configure relays #5 and #6. This setting will
always configure both relays #5 and #6.