Instruction Manual

DataView™ LI55 Level Controller Instruction Manual

53 | Page

Setting the Relay Action

Operation of the relays is programmed in the Action menu. The relays

may be set up for any of the following modes of operation:

1. Automatic reset (non-latching) [default & typical for most

applications]

2. Automatic + manual reset at any time (non-latching)

3. Latching (manual reset only, at any time)

4. Latching with Clear (manual reset only after alarm condition

has cleared)

5. Pump alternation control (automatic reset only)

6. Sampling (the relay is activated for a user-specified time)

7. Off (relay state controlled by Interlock feature)

The following graphic shows relay 1 action setup; relay 2-8 are set up in

a similar fashion.

ENTER ENTER