Instruction Manual

DataView™ LI55 Level Controller Instruction Manual

42 | Page

Setting the Input Signal (Input)

Enter the Input menu to set up the meter to display current (mA) or

voltage (

volt) inputs. The default input is mA, and it does not need to

be changed when using current inputs.

The current input is capable of accepting any signal from 0 to 20 mA.

Select current input to accept 0-20 mA or 4-20 mA signals.

The voltage input is capable of accepting any signal from -10 to +10 VDC.

Select voltage input to accept 0-5, 1-5, 0-10, or 10 VDC signals.

Dual-Scale

After selecting mA or Volt input, d-SCAL is displayed; press Enter to

select “Yes” or “No”. Selecting “Yes” enables the dual-scale feature,

which allows for the Scale (SCALE) and Units (units) menus to be used

to scale the same input in two different scales for PV1 & PV2.

Set d-SCAL to no if both displays are to be used for anything

other than PV1 & PV2.

ENTER

ENTER UP