Instruction Manual

DataView™ LI55 Level Controller Instruction Manual
20 | Page
Connectors Labeling
The connectors’ label, affixed to the meter, shows the location of all
connectors available with requested configuration.
Warning!
Do not connect any equipment other than
Flowline’s expansion modules, cables, or
meters to the RJ45 M-LINK connector.
Otherwise damage will occur to the equipment
and the meter.
Figure 7. Connector Labeling for Fully Loaded LI55
Power Connections
The external power source to DataView is connected through a two-
terminal connector labeled
POWER on Figure 7 on page 20. The meter will operate regardless of DC
polarity connection. The + and - symbols are only a suggested wiring
convention.
AC or DC
POWER
Required External Fuse:
5 A max, 250 V Slow Blow
POWER
+
-
Figure 8. Power Connections