Instruction Manual

DataView™ LI55 Level Controller Instruction Manual
100 | Page
Display Parameter Action/Setting Description
done
Done
Copy function completed
d-SCAL
Dual-scale
Enter d-SCAL menu and select Yes for dual-
scale display or
No for single scale display
DSet 1
Display set 1
Select to display set point 1 (1-8)
dsplay
Display
Enter the Display menu
Empty
Empty
Enter value at 4 mA
Enter
Enter button
Assign digital input to Enter button
Error
Error
Error, calibration not successful, check signal
or programmed value
F On 1
Force On 1
Force relay 1 on using digital input
F1
F1 function key
Assign F1 function key (Right button)
F2
F2 function key
Assign F2 function key (Up button)
F3
F3 function key
Assign F3 function key (Enter button)
F4
F4 function
Assign F4 function (digital input)
FaiLSF
Fail-safe
Enter Fail-safe menu
filter
Filter
Set noise filter value
FLS 1
Fail-safe 1
Set relay 1 fail-safe operation (1-8)
Force
Force
Force analog output value for loop break
Full
Full
Enter value at 20 mA
Functn
Signal input
conditioner
Select linear, square root, programmable
exponent, or round horizontal tank function
ICal
Internal source
calibration
Enter internal source calibration (used for
scaling the meter without a signal source)
ignore
Ignore
Ignore loop break condition
Info
Information
Display software and S/N information
Inp 1
Input 1
Calibrate input 1 signal or program input 1
value
Inp 2
Input 2
Calibrate input 2 signal or program input 2
value (up to 32 points)
Input
Input
Enter Input selection menu
LatCH
Latching
Set relay for latching operation