Instruction Manual

RevA MN204260 11of16
INSTALLATION StepSeven
PodView® is designed for typical panel mount installations, either located within an instrument panel or
throughthewallofaNEMAboxenclosure.
PanelMount:ThemaximumcabledistancebetweenPodView®andEchoPod®is15’(4.5m).Followthebelow
stepstoinstalltheindicatorinapanelorNEMAboxenclosure
locatednearEchoPod®:
1. Drill(1)large0.75”(19.1mm)diameterholein the
panelforthecableandnipple.
2. Drill (1) small 0.25” (6.4mm) diameter hole 0.83”
(21.1mm) below the large hole that will prevent
theinstalledindicatorfromrotatingoffcenter.
3. Runtheindicatorcable throughthelarge
tophole
andlockingnut(ontherearsideofthepanel).
4. Properly align the indicator with the flat gasket
and holes on the panel. Then press the indicator
inplaceagainstthepanel.
5. Tighten thelockingnutdownoverthenippleand
routethecablefortermination.



