User guide

LI25 Series Loop-Powered Meters Instruction Manual

Setting Up the Bargraph (GrapH)

The meter can be set to display a bargraph proportional to the

percentage process reading within a user-defined span.

The span is determined by values entered for 0% and 100%.

If the 0% and 100% values are the same as the values that were

entered for display 1 and display 2, respectively, from the scale or

calibrate steps, then it is not necessary to modify them.

The bargraph may be disabled by selecting OFF from the bargraph

menu.

100PCT

0PCT

Set 0%

Value

-ON-

00.000

Set 100%

Value

Press Up to Set Digit Value

Press Right to Select Next Digit

Press Menu to Exit at any Time

50.000

GrapH

-OFF-

Run Mode