Instruction Manual

RevB MN301030 5of14
SAFETYPRECAUTIONS StepFour
AboutthisManual:PLEASEREADTHEENTIREMANUALPRIORTOINSTALLINGORUSINGTHISPRODUCT.
ThismanualincludesinformationonallversionsoftheDeltaSpanSeriesIndustrialPressureLevelTransmitter 
fromFlowline;modelsLD30‐____.Pleaserefertothepartnumberlocatedonthetransmitterlabeltoverify
theexactmodelwhichyouhavepurchased.
User’s Responsibility for Safety:Flowline manufactures a wide range of liquid level sensors and
technologies.Whileeachofthesetechnologiesaredesignedtooperateinawidevarietyofapplications,itis
the user’s responsibility to select a technology that is appropriate for the application, install it properly,
perform tests of the installed system, and maintain all components.The failure to do so could result in
propertydamageorseriousinjury.
Proper Installation and Handling:Only properly‐trained staff should install and/or repair this product.
Useapropersealantwithallinstallations.Alwayscheckforleakspriortosystemstart‐up.
Wiring and Electrical:CAUTION:A supply voltage of 13 to 30 VDC is used to power the LD30 series
transmitter.Electrical wiring of the sensor should be performed in accordance with all applicable national,
state,andlocalcodes.
TemperatureandPressure:TheLD30seriesisdesignedforuseinapplicationtemperaturesfrom‐18°to
93°C(0°to200°F),andforuseatpressuresupto2xthefullspanoftheLD30series.
Material Compatibility:The Industrial pressure level transmitter, LD30 series, is made of 316 Stainless
Steel (316 SS) and 316L Stainless Steel (316L SS).Make sure that the model which you have selected is
chemicallycompatiblewiththeapplicationliquids.
Flammable, Explosive and Hazardous Applications:DO NOT USE THE DELTASPAN, LD30 SERIES LEVEL
TRANSMITTERINHAZARDOUSLOCATIONS.
Make a Fail‐Safe System:Design a fail‐safe system that accommodates the possibility of transmitter
failure or battery power loss.In critical applications, Flowline recommends the use of redundant backup
systemsandalarmsinadditiontotheprimarysystem.

