Instructions / Assembly

BUTTERFLY BENCH ASSEMBLY INSTRUCTIONS
The tools provided are a 9 cm open end wrench and a 7 cm allen wrench for body,
wings, seat, and antenna assembly.
Step 1: Start by bolting wings to butterfly body. Body goes on the BACK of wings
and will “face” towards the back. (Do not fully tighten until all fasteners are in place
on entire bench).
Step 2: Place seat in position and start fasteners. Seat portion will set donwn on top
of the four mounting tabs. (Do not fully tighten until all fasteners are in place on
entire bench).
Step 3: Place antenna in position and start fasteners. With all the fasteners loose,
you may need to physically rock the bench around to align the holes.
Step 4: Snug nuts and bolts gradually by moving from fastener location on body,
wings, seat and antenna with Allen key and open end wrench.
Step 5: Once the fasteners are consistently tightened then your Butterfly Bench is
ready to be used as a bench.