Specifications
Document Doc.Id. Version
Name of document GR 21-005 01
11. How to Perform a
Treatment
Session
-
Ensure your forehead is free from any makeup or hair products before you start.
- If you have a fringe, it is recommended that you use a hair tie to remove it from your
forehead.
- Take out the headset from the box.
- Press the button on the headset and make sure it blinks twice. If not, charge the
headset.
- Make sure Bluetooth is enabled on your smartphone.
- Start the Flow app and log in with the email address & password you chose in section
9 above.
- Select the next session in the app and press “Start” to start the session. Note that
how often you can use the headset is restricted per week and day.
- Follow the instructions given by the virtual therapist in the app.
- When told to, follow the instructions on how to prepare the headset, as below:
■ Take a new pair of Headset Pads from the pouch. Attach them to the
electrodes using the Pad Holder Rings.
■ Adjust the length of the metal arch by sliding the back piece.
■ The end of the arch should sit comfortably on the back of your head. Make
sure the headset does not sit too low.
■ The app shows you how to correctly position the headset using the camera
on your device.
■ Before starting the stimulation, you can press and hold the “Tingle” button in
the app to test how the stimulation feels. Hold the “Tingle” button for at least
10 seconds.
■ Start the stimulation by pressing the “Start stimulation” button in the app.
- The current will now slowly increase to its maximum of 2 mA, as shown in the app.
- If you at any point want to pause the stimulation, press the pause button in the app or
the button on the headset.
- Follow the instructions in the app during the rest of the session. The session will last
for 30 minutes.
- When the time is up, the headset will automatically start decreasing the current.
- Do not remove the headset before the app indicates that the stimulation has
stopped.
- The headset gives a “beep” signal when the stimulation has finished.
- After the session, dispose of the Headset Pads and put the Pad Holder Rings and
headset back in the box.
- The headset
will automatically turn itself off after a few minutes of inactivity. Start
it again by pressing the button on the headset.
Template Doc.Id. Version
Core Text Template FL 09-04-01 TMP 03