Operation Manual

Problem: The console / display will not turn on.

Solution: -Check if the treadmill is pugged into a grounded outlet.

- Check if the 0 / I switch is on (I) . The switch is near the power cord on the

back of the motor cover.

- Check the fuse near the switch. If the fuse is broken, please contact your

dealer.

Problem: Segments of the display don’t light up.

Solution: LEDs of the display are damaged; please contact your dealer.

Problem: display shows “- - “.

Solution: The safety key is missing. Place the key in the designated place to use the

treadmill.

Problem: The treadmill is running rough.

Solution: There is not enough lubricant between the belt and the running deck.

The treadmill should be lubricated at regular intervals.

Problem: The running belt slips on the rollers.

Solution: The belt needs to be tensioned. How to tensioning the belt is described in

chapter 4.2.

Problem: When touching metal parts of the treadmill static electricity is released.

Solution: - The treadmill should be powered by an grounded outlet.

- The running surface needs to be lubricated. Friction is created between the

belt and running board. This causes static energy and can be prevented by

regular lubrication.

Problem: The display shows error code E1.

Solution: An abnormal value is send to speed sensor. Perform the following steps:

1. Remove power from the treadmill (by unplugging the product from the

outlet), wait 10 seconds before turning on the power again.

2. Press START/STOP and check the following:

a. Does the belt starts to move?

b. If the belt is moving, is the error code E1 still in the display?

3. If the treadmill is running correctly, tension the belt again and lubricate the

running surface (chapter 4.4 of this manual)

If the belt is not rotating or error code E1 is still visible, please contact your

dealer.

5.3 Troubleshooting

5. General information