Operation Manual

4. Use

Maintain the sliding surface

Every 1 or 2 months or every 50 hours of use, your advised to lubricate the

sliding surface under the running deck with the included silicone lubricant.

When lubricating the running deck, make sure the power cord is unplugged,

so there is no power going trough the treadmill. Loosen the adjustment

screws of the rear roller. Then put some lubricant on either side of the

running deck and spread evenly. When you’re done, you can center the belt

and fasten the adjustment screws.

Cleaning and maintenance

Important. Switch the treadmill off before cleaning. The on / off switch is

located behind the motor cover

Wipe the product and al its parts clean after every work out. This prevents

sweat marks what could lead to corrosion of the product.

The metal and plastic parts of the treadmill can be cleaned by using stan-

dard cleaning products. However, make sure that all parts are completely

dry before they are used again.

Flow Fitness advises to check and if necessary tighten all nuts and bolts

every six weeks. For tightening use the supplied tools.

To prevent damage and wear to the treadmill, the product can only be used

indoors and in a dry environment.