Use and Care Manual

Installation 8
For parts or assistance, call Flotec Customer Service at 1-800-365-6832
3“ NPT Spinweld
Vent Fitting
7-7/16”
2-7/16”
39-5/8”
5-3/8”
19-1/4”
Min. 6-1/2”
14-1/2”
12-5/8”
12”
24-1/4”
Cut 3” hole with holesaw to run drain line
from an additional fixture into tank. Center
of hole must be at least 6-1/2” above bottom
of tank. Use grommet to seal pipe where it
runs into tank. Be sure to support pipe to
take its weight off side of tank.
Figure 6: Add-a-Jon Dimensions.
Performance
Gallons of Water Pumped per Minute at Specified feet of Lift
Lift in Feet (m) 18 (5.5) 14 (4.3) 12 (3.7) 10 (3.1) 8 (2.4) 6 (1.8) 4 (1.2)
Gallons per Minute 0 35 (132) 47 (178) 60 (227) 70 (265) 80 (303) 92 (348)