Use and Care Manual

Installation 4
For parts or assistance, call Flotec Customer Service at 1-800-365-6832
Installation
Follow the Add-a-Jon installation instructions and all
applicable national or local electrical and plumbing
codes for a good installation. Thorough planning is a
must. Get the right tools for the job before beginning,
and make a specific and thorough plan. Many localities
will require you to make drawings, obtain a building
permit and/or have your work inspected. Be prepared;
read all instructions that come with this product
beforeinstallation.
Retain this owner’s manual for future reference.
Parts and Basic Tools Needed:
Some of the tools may not be needed depending on the
type of installation.
• 2”PVCCloseNipple
• 2”90°PVCSlipElbow
• 2”SlipUnion
• 2”Slipx3”NPTReducerBushing
• PipeGlue(tomatchpipeyouareusing-probably
PVC or ABS cement)
• VentPipe(seeStep14,Page6)
• 5/16”Nutdriver
• 7/16”and1/2”Wrenches
• Carpenter’sLevel
• CenterPunch
• Cloths,Rags
• 4”ExpandablePlumber’sPlug
• Hacksaw
• Hammer
• HoleSaw(3”)
• Marker
• FlatScrewdriver
• Sponge
• StrapWrench
• TapeMeasure
• WallboardKnife
See Figure 1 for the basic plumbing layout.
Purchase Separately:
2 - 2” x Close Nipples
1 - 2” Slip Union
1 - 2” Slip 90° Elbow
Adapter
Foam
Gasket
Check Valve
Cord
Grommet
Pipe Grommet
Discharge Pipe
5159 1005
Figure 1: Piping Components and Layout.