Installation Guide

Page 14 of 36 versatile™ 4C Installation Manual -- 206362 -- Rev A
www.orencemailboxes.com
COLLECTION BOX MODULE INSTALLATION
versatile™ 4C mailbox suites
1 .
While looking at the back of the collection box module, slide and hold the sliding latch up
past the latch hook.
2 .
The master door can now be opened to gain access to the mounting screw holes/slots for
installation.
3 .
Remove all hardware located inside the module and set aside.
4 .
Place the collection box module in the opening until the integrated trim is flush with the wall
board.
5 .
Refer to “Individual Installation” (p. 20) or “Multiple Installation” (p. 22), as appropriate,
and proceed with installation.
NOTE: If a factory installed private door lock was ordered, open the
collection door using the keys taped to the side of the module.
IMPORTANT: When installation is complete, make
sure you have removed all hardware located
inside the module before closing the door(s).
ADJUSTMENT TIP: If access to the mounting screws is necessary for installation
adjustment, open the collection door, and find a latch hook location.
• The hopper handle must be removed before the master door will open.
• Insert a #1 screw driver between the master door and the module frame,
and slide the sliding latch up until the master door has disengaged.