Installation Guide

Page 22 of 36 versatile™ 4C Installation Manual -- 206362 -- Rev A
www.orencemailboxes.com
MULTIPLE INSTALLATION USING FLORENCE’S EXCLUSIVE
MULTI-UNIT CONNECTOR KIT
1 .
Place the first module at the right-hand side of the rough opening until the integrated trim is
flush with the wall board.
2 .
Open the master door(s) until the hold open arm(s) engage(s).
• Collection Box module:
Remove the tape that secured the hopper for shipping, allowing the hopper to
drop down out of the way to gain access to the mounting screw locations (see p.
21).
3 .
Install the included #8 x 2” pan-head T20 Torx wood screws (64225) along the right-hand
outer frame.
4 .
Install the included #8 x 2” pan-head T20 Torx wood screws (64225) along the top and
bottom frame.
1). Parcel-only module -- Return to p. 12, Step 6 to complete the installation before
going on to Step 5.
2). Collection box module -- Go to p. 32 to install the hopper door handle before
going on to Step 5.
NOTE: Only front-loading tenant or tenant w/ parcel units have a hold open
arm.
• When installing a rear-loading module, parcel-only module,
collection box module, or trash/recycling bin, you may ignore all
references to hold open arm(s) in the remainder of the text.
NOTE: The #8 x 2” pan-head T20 Torx wood screws (64225) should
be tightened to ensure a snug fit.
• Overtightening beyond initial contact with frame could
hinder functionality.
• If overtightening occurs, simply back out each
overtightened mounting screw.
versatile™ 4C mailbox suites