Installation Guide

Page 12 of 36 versatile™ 4C Installation Manual -- 206362 -- Rev A
www.orencemailboxes.com
PARCEL-ONLY MODULE INSTALLATION
versatile™ 4C mailbox suites
1 .
While looking at the back of the module, slide and hold the sliding latch up past the latch
hook.
2 .
The master door can now be opened to gain access to the mounting screw holes/slots for
installation.
3 .
Remove all hardware located inside the module and set aside.
4 .
Place the parcel-only module in the opening until the integrated trim is flush with the wall
board.
5 .
Refer to “Individual Installation” (p. 18) or “Multiple Installation” (p. 22), as appropriate,
and proceed with installation.
After fastening the parcel-only module into the opening:
6 .
Close the master door.
7 .
Open the parcel doors using the parcel door keys included with the hardware.
8 .
Install all slide lock(s) (64256) and secure with #10-32 x 3/8” one-way screw(s) (84994) in
each parcel locker in the module.
IMPORTANT: When installation is complete, make
sure you have removed all hardware located
inside the module before closing the door(s).
ADJUSTMENT TIP: If access to mounting screws is necessary for installation
adjustment, open the parcel doors and remove all #10-32 x 3/8” one-
way screw(s) (84994) and all slide lock(s) (64256) per each parcel
locker in the module.
• Disengage the sliding latch by placing a small allen wrench (hex
key) in the slide lock slot and sliding the sliding latch upward.
• The master door can now be opened.