Operation Manual

14
IE
GB
Spare parts
The following spares are available from
Grizzly Service-Center (see P. 21 for the
address). Please indicate the machine type
and the number of the spare part with your
order.
Spare blade
...............................13700300
If further spare parts should be necessary,
please nd the part number on the exploded
drawing.
Technical
Specications
Electric Lawnmower ......... FRM 1800 A1
Motor input power ......................... 1800 W
Mains voltage ......................230V~, 50 Hz
Idling speed .............................. 3250 min
-1
Blade width ..................... Approx. 440 mm
Cut height ...............................20 – 70 mm
Protection class ...................................
II
Protection type.................................. IP 24
Weight ...........................................18.7 kg
Lawn bag volume ................................50 l
Sound pressure specication
(L
pA
) ............74.8 dB(A); K
pA
= 2.26 dB(A)
Noise level specication
measured (L
WA
)
.................. 93.9 dB(A); K
wA
=2.26 dB(A)
guaranteed ............................96.0 dB(A)
Vibration on the handle
(a
n
) ...................... 2.07 m/s
2
; K= 1.5 m/s²
Do not exceed the maximum permitted
network impedance of 0.277 Ohms at the
electrical connection point
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure as-
sessment.
Warning: The vibration emission
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at protect-
ing the user should be based on
estimated exposure under actual
usage conditions (all parts of the op-
erating cycle are to be considered,
including, for example, times during
which the power tool is turned off
and times when the tool is turned on
but is running idle).
The noise and vibration values have been
determined in accordance with the stand-
ards and regulations specied in the decla-
ration of conformity.
Technical and visual modications may be
made without notice in the course of further
development. All dimensions, informa-
tion and specications in these operating
instructions are therefore not guaranteed.
As such, no assertion of legal claims can
be enforced on the basis of the operating
instructions.