Operation Manual

23
GB
Operation
Hanging On / Removing the
Grass Box
E
1. To hang on the grass box (4),
lift the collision guard (7) and
hang on the grass box. Fold the
collision guard (7) onto the grass
box (4). It holds the grass box in
the correct position.
2. To remove the grass box (4),
lift the collision guard (7) and
detach the grass box. Fold the
collision guard (7) back onto the
mower housing (6).
The level gauge (
D
20) is located on the
side of the grass catcher (4).
Flap (
D
20) open:
grass catcher (4) empty
Flap (
D
20) closed:
grass catcher (4) full
Adjusting the Cut Height
Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The lawn mower can be set to the follow-
ing cut heights by means of three position
changes of the front and rear wheels, ad-
justing the individual wheels:
60 mm - Tall cutting height
40 mm - Medium cutting height
20 mm - Short cutting height
F
1. Unscrew the wheels (5).
2. Screw the wheels (5) back on in
the desired position.
The correct height is around 25 – 40 mm
for a decorative lawn and around 30 – 60
mm for a used lawn.
A higher cut height should be se-
lected for the rst cut of the season.
Observe the noise protection and
local regulations.
Switching On and Off
1. Insert the power cable plug into
the socket (
A
9) on the curved
handle (
A
1).
2. To relieve the strain, form a loop
with the end of the power cable
and hang this into the strain reli-
ef (11). See the diagram
.
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press the release
button (10) on the handle at the
same time as pressing the start
lever (12). Release the release
button (10).
6. To switch off, release the start
lever (12).
After switching off the equipment,
the blade continues to turn for sev-
eral seconds. Do not touch the mov-
ing blade. There is a risk of injury.
Working with the
Lawnmower
Regular mowing encourages increased foli-
ation of the grass and kills off weeds at the
same time. Therefore, not only does each
mowing increase the density of the lawn, it
also produces an evenly resilient lawn.
The rst cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Start mowing near the socket and work
away from the socket.