Full Product Manual
July 2018 Floorworks® Page 3 of 10
Floorworks
®
3mm has a limited warranty (available at www.matsinc.com) of 10 years for heavy commercial, 2.5mm has 10
years for light commercial and both are 20 years for residential use when installed and maintained according to the product
instructions.
LEED v4
Information
Many finishing products have the potential to contribute points to LEED v4. However, the credits can only be gained when
calculating the combined performance of all the products used on a particular LEED project; therefore no single product
can guarantee you will obtain LEED v4 credits.
Floorworks
®
may contribute to the following LEED credits (points), the following is based on LEED NCv4:
v4 MRp2: Material and Resources – Construction & demolition waste management planning:
The tiles or planks reduce waste from the installation process, reducing waste in landfills.
Made from recyclable material and / or is a reusable product, reducing waste in landfills.
v4 MRc1: Material and Resources – Building life-cycle impact reduction:
Option 3. Building and material reuse. This product can be reused or salvaged from off-site or on-site as a percentage
of the surface area. Note: Materials contributing toward this credit may not contribute toward MRc3.
v4 MRc2: Material and Resources – Building product disclosure and optimization,
environmental product declarations:
Option 1. Environmental product declaration (EPD) is available.
v4 MRc3: Material and Resources – Building product disclosure and optimization, sourcing of
raw materials:
Option 2. Sourcing of raw materials.
Recycled content. Recycled content is 28% pre-consumer.
v4 EQc2: Indoor Environmental Quality – Low emitting materials:
Option 1 (Flooring). General emissions evaluation. Verified third-party FloorScore
®
certificate is available and meets
the CA 01350 requirements.
Option 1 (Adhesives). Verified third-party FloorScore
®
certificate for MI 1000 Adhesive and Spray-Lock 6500 are
available.
Option 2. Budget Calculation Method.
Conditions & Storage
Conditions
Areas must be enclosed weather tight and properly conditioned at a constant (± 5°F) service temperature that is between
65°F and 80°F with ambient relative humidity between 35% - 65%. In addition, the substrate surface must be at least 5°F
above dew point for 72 hours prior to, during, and for 24 hours after the installation.
Note: Dew point calculators are available on the web. Windows etc. must also be covered for 2 hours prior, during, and for
24 hours after installation.