Owner's Manual

2. Press the Switch Button on the Handle to turn on the Flomo. Press the Max Mode Button
to switch the suction power.
Switch Button
Max Mode
Spray Button
****** Important tips:
• Please choose the Hard Roller Brush for areas with short rug if you ordered the Hard
Roller Brush.
• Please DO NOT use Flomo in the LONG rug areas.
• Please DO NOT use Flomo in the delicate rugs, silk or similar floors.
• Please DO NOT SPRAY on the rugs.
2. Hold the Spray Button for 8 seconds to prime the cleaning water/solutions before each
use. Spray the water according to your personal use during the cleaning.
3. Hold the handle and pull the Flomo forward and backward to clean your floors.
4. The angle range of handle tilt must be within 60.5 degree(up and down), please do not
shake it in use.
60.5°
Backward
forward
****** Important tips:
• Please DO NOT run over the edges of the rugs.
• The UV lamp will work automatically if your choose the version with UV lmap. The UV
lamp will stop to work when turn off the Flomo or it detects that the floor brush set is off
the floor. Please
DO NOT expose the human or animals to the UV Lamp in case any Ultraviolet radiation.
• The Dirty Water Tank must be cleaned as soon as the cleaning work finished, or it will
be stinky.
• DO NOT turn the main body overbefore cleaning the Dirty Water Tank, or the dirty
water will flow into the vacuum motor and damage Flomo.
5. Please clean the Dirty Water Tank after each use of cleaning.
11