Owner's Manual

6. Insert the Roller Brush into the base of brush, rotate the Roller Brush so that the brush

can align with the brush, meanwhile, make sure that the lock can align with the lockhole,

then lock the Roller Brush.

Filling up the Clean Water Tank

1. The cleaning water tank is located on the back of the main body, use your fingers

to grab the top of the water tank and pull it upwards to remove.

2. Unscrew the water cap counterclockwise as below and add some water, then screw

it and insert the Clean Water Tank into Flomo.

• Please do not screw the cap too tightly or too loosely, or the cap may be broken or

the water tank will be leaking.

• Users can also add some cleaning solutions which are non corrosive or flammable

liquid to clean the floor, DO NOT add dirty water into the clean water tank.

• It is normal if there is some water in the water tank at the first use, tests and inspections

are proceeded before goods leaving factory,