User's Guide

CONFIGURING THE CONNECT MODULE

1. Ensure that the Module mounting location is in an area with a strong 2.4 Ghz

WiFi signal. For an existing FloLogic setup, remove the Communication Cable

from the back of the FloLogic Control Panel; on a new setup, use the

Communication Cable from the FloLogic Valve.

2. Plug the black Communication Cable into the bottom of the Connect Module in

the right-side port, as you’re looking at the front of the Connect Module.

3. Then use the supplied white Local Connection Cable to plug into the left-hand

port of the Connect Module, plugging the other end into the existing Control

Panel. Cutting out the removable tab (depicted on the next page) on the

Control Panel may make this connection easier.

Extensions and longer lengths of the Communication Cable from the Valve are

available if required. Any standard telephone line cord can be used for the Local

Connection Cable, provided it is 4-conductor or greater and has “reversed”

plugs.