FT Tiny Trainer Assembly Guide

9
Procedures You Will Be Using :
A TYPE FOLD
Fold the side wall so that the cheeks are glued
on top of the bottom plate as depicted.
See illustration.
Z-BEND
Use Pliers to bend your Push Rods into a “Z.”
B TYPE FOLD
Fold the side wall so that the cheeks are glued
to the side of the bottom plate as depicted.
See illustration.
BEVEL
Use your Exacto Knife or Sandpaper to make
an angle along the specified side of foam,
being careful not to cut though the paper.
SCORE CUT
Use your Exacto Knife to make a shallow cut,
taking care not to cut through the bottom paper.
DOUBLE BEVEL
Use your Exacto Knife or Sandpaper to create
a shallow angle on both sides of the foam.
CUT THROUGH
Use your Exacto Knife to cut through the foam
and the paper so that the piece can be separated
completely.
SQUEEGEE
Use a spare piece of foam to wipe off excess
hot glue.
ETCH/CREASE
Use your Exacto Knife or Barbecue Skewer to
make a small cut or score, opening up the area
so it will fold/break more easily.
DRY FIT
When you see the words “dry fit”, attach or
fold the foam pieces together without any glue
to make sure the fit is to your liking.