FT Tiny Trainer Assembly Guide

57
ATTACH YOUR POWER POD TO YOUR POWER NOSE
1. Put Velcro on the bottom plate of your Power Pod (Illustration 18).
2. Lace the wires down through the Power Nose with the Velcro facing down
towards the bottom (Illustration 19).
3. After the Power Pod is seated against the top plate, use your Skewer to
puncture the holes on both sides (Illustration 20).
4. Pass the Skewer through the holes.
5. Cut two Skewers the same length, smaller than the ones used to attach your
nose.
6. Pass the Skewers through the holes to attach the Power Pod (Illustration 21).
THE BUILD POWER POD & ELECTRONICS