FT Tiny Trainer Assembly Guide

CALIBRATE YOUR ESC

1. Remove the prop from your Power Pod. Connect your ESC to the Motor

(Illustration 14).

2. Place a piece of tape around the Motor (Illustration 15). This will help you tell if

it’s running clockwise or counterclockwise (it should run counterclockwise).

3. Turn on the Transmitter, and move the throttle stick all the way up

(Illustration 16).

4. Connect your Battery to the ESC, wait for two beeps and move the throttle stick

all the way closed. When your Transmitter beeps again, your ESC will

be calibrated.

5. Push up on the throttle a little to see which way the Motor is running. If it’s

running clockwise, swap two Leads from your ESC wire (Illustration 17). You

can swap any two you want.

6. Test the throttle again to make sure it’s running counterclockwise. Pull the throttle

all the way down, and remove the tape from the Motor. Unplug the Battery.

THE BUILD POWER POD & ELECTRONICS