FT Tiny Trainer Assembly Guide

54
ATTACH YOUR MOTOR
1. Use your Small Knife to open up the holes in the Firewall covered with tape
(Illustration 8).
2. Screw a small length screw (provided with Motor) into the hole on the right
(Illustration 9).
3. Line up the screw with the Motor, and screw it in halfway.
4. Screw in another screw on the other side.
5. This should screw in easily, but if you encounter resistance, don’t screw tighter
because that could create cross threading and ruin the Motor.
6. After you tighten the screws, the inside should look like Illustration 10.
THE BUILD POWER POD & ELECTRONICS