FT Tiny Trainer Assembly Guide

THE BUILD ADVANCED WING

ATTACH LINKAGE STOPPERS TO YOUR AILERON SERVOS

1. Open up the wire hole (Illustration 24) and the two etched squares

(Illustration 25).

2. Grab your Servos, and install the Linkage Stoppers into the second hole of the

control arm (Illustration 26).

3. You will need to enlarge the second hole by carefully rotating your Knife in the

hole until it’s big enough to ﬁt the screw of the Linkage Stopper (Illustration 27).

4. Slide the Linkage Stopper into the hole, and secure with a wing nut on the other

side (Illustration 28).

5. Screw a small screw into the top of the Linkage Stopper (Illustration 29). Don’t

screw it all the way in until after you have guided your Push Rod through the

Linkage Stopper.