FT Tiny Trainer Assembly Guide

34
PREPARE THE FOAM PIECES OF YOUR TRAINER WING
1. Pop out the pieces for your Trainer Wing. Take the two large halves, line them
up side by side and put a little tape on each end to hold it together
(Illustration 1).
2. Take a longer piece of tape, and cover the entire seam (Illustration 2),
smoothing the tape out with your Drafting Triangle and leaving some extra tape
on either side (you’ll fold this over later). When you pick it up, it should have a
nice hinge.
3. On the untaped side, fold the hinge back, and put glue on the foam in the
seam (Illustration 3). Try not to glue the tape because it could melt.
4. Lay the wing flat, grab a scrap piece of foam and smear the excess glue all
along the seam. Fold the extra tape over on top of the seam. Hold the wing flat
with your hands until dry.
THE BUILD
TRAINER WING