FT Tiny Trainer Assembly Guide

28
ATTACH GLIDER NOSE TO FUSELAGE
1. Remove the Skewer, and use your Knife to cut it, rolling the Skewer underneath
your Knife and pulling it apart (Illustration 14).
2. Use your first cut Skewer to measure another piece of equal length.
3. Place the cut Skewers back in the holes to secure the nose to the Fuselage
(Illustration 15).
4. Pull the hatch down, and insert the tab into the opening.
5. Glue the tab down to the top hatch (Illustration 16).
6. Put a little glue on the bottom of the tab as well to keep it from delaminating.
7. Use a scrap piece of foam to spread the glue around the entire bottom portion
of the tab.
THE BUILD GLIDER NOSE