FT Tiny Trainer Assembly Guide

THE BUILD GLIDER NOSE

COMPLETE GLIDER NOSE BODY

1. Do a dry ﬁt with your hatch piece on your Glider Nose (Illustration 5).

2. Press the bottom plate on top of the paper at the end of the hatch piece, using

glue to anchor the bottom plate to the paper (Illustration 6).

3. Press hard against the table, and allow glue to dry.

4. Roll the hatch piece up and over the front end of the nose (Illustration 7).

5. Go slowly so that the foam bends to match the curve of the nose. When you’re

happy with the curve, put glue down on the portion up to the fold, and stop a

centimeter or half an inch from the seam (Illustration 8).

6. Do not glue the other portion! This will be the hatch that allows you to put clay

or electronics inside the nose. Make sure you pull the bottom half up into the

nose, and apply constant pressure until it’s dry (Illustration 9).