FT Tiny Trainer Assembly Guide

24
PREPARE THE FOAM PIECES OF YOUR GLIDER NOSE
1. Pop out the Glider Nose body, hatch and doubler pieces.
2. Use your Knife to score cut as close to the paper as possible.
3. Remove the excess foam with your fingers and your Knife.
4. Put some glue on the back of the doublers, and place on the etch marks inside
the nose (Illustration 1 and Illustration 1a).
5. Hold until dry, and then repeat for the other doubler.
6. Do a test B fold on the nose. Put glue on the foam part of the bottom plate,
make your B Fold, and hold until dry.
7. Use your Drafting Triangle to make sure the sides stay square (Illustration 2).
Repeat process with the other side.
THE BUILD
GLIDER NOSE