FT Tiny Trainer Assembly Guide

THE BUILD FUSELAGE

GLUE YOUR SERVOS INSIDE YOUR FUSELAGE

1. Using your Pliers or Z-bend Pliers, make a vertical Z-bend on both Push Rods

inside the Fuselage (Illustration 29).

2. Use Wire Cutters to cut off any excess, being careful not to point it at yourself

or anyone else while doing so.

3. Pass one Push Rod through the Control Horn.

4. Do a dry ﬁt to ensure that the Rudder is centered, and move the Servo away

from the Fuselage wall.

5. Place a drop of glue on the side of the Servo, and attach it to the side of the

Fuselage (Illustration 30).

6. Let dry, and then repeat the process with the other Servo.

7. As the second Servo dries, you may want to use a Screwdriver to hold the

Servo up against the wall of the Fuselage (Illustration 31).