FT Tiny Trainer Assembly Guide
21
THE BUILD FUSELAGE
CENTER YOUR RUDDER AND ELEVATOR SERVOS
1. Grab two Servos, and take out all of the components.
2. Plug the Servo wire into the aileron port of your Receiver (Illustration 26).
3. You want to make sure all the Servos are centered on their trims. Power up your
Transmitter with the throttle closed (Illustration 27).
4. Press the button on your Transmitter, listening for one long beep.
5. Do this for both trims of your Servo.
6. Power up your Servo by plugging the Battery into the ESC wire.
7. Put a control arm on your Servo, and check for motion by moving the right stick
of your Transmitter.