FT Tiny Trainer Assembly Guide

THE BUILD FUSELAGE

CONTROL HORNS FOR YOUR FUSELAGE

1. Pop out your Control Horns. Take one Control Horn, and press it into the slot on

the Rudder (Illustration 23).

2. The hole in the Control Horn should be directly over the hinge line.

3. Remove the Control Horn, and slide the Z-bend of your Push Rod into the hole,

keeping the Z-bend on the inside of the Control Horn (Illustration 24).

4. Do another test ﬁt to ensure the Control Horn has a full range of motion, and

then glue into place.

5. Hold until thoroughly dry.

6. Repeat the process on the Elevator (Illustration 25).