FT Tiny Trainer Assembly Guide

THE BUILD FUSELAGE

ATTACH YOUR TAIL ASSEMBLY TO YOUR FUSELAGE

1. Use your Knife to cut the notch on the top of your Fuselage, and continue the

cut all the way to the edge, using your Steel Ruler or Drafting Triangle as a

reference guide (Illustration 18).

2. Guide the tail assembly into the Fuselage to test the ﬁt (Illustration 19), using

your Drafting Triangle to make sure it is perpendicular (Illustration 19a).

3. Slide the tail assembly down so that the bottom of the Fuselage is exposed

(Illustration 20).

4. Place glue on the bottom foam of the Fuselage, and then rotate the tail

assembly into place (Illustration 21).

5. Hold your Drafting Triangle against the Rudder to ensure it dries square.

6. Once it’s dry, place some glue on top of the foam at the end of the Fuselage

(Illustration 22).

7. Use a scrap piece of foam to remove the excess.