Manualshelf

FT Tiny Trainer Assembly Guide

ManualsBrandsFlite Test ManualsAirplanesMighty Mini Tiny Trainer Speed Build Electric Airplane Kit (940mm)
11121314151617181920
18
THE BUILD FUSELAGE
MAKE YOUR TAIL ASSEMBLY
1. Use your Knife to cut through the etch mark on the stabilizer side of the
Elevator.
2. Remove the foam, and then take your Rudder and insert it into the opening
(Illustration 15).
3. Use your Drafting Triangle to make sure it is perpendicular.
4. Place glue on the foam side of the fin, skipping the keel.
5. Insert the Rudder into the opening on the Elevator. Because the keel will stick
out from the bottom, it is best to do this on the side of the table (Illustration 16).
6. Hold until dry, using your Drafting Triangle to ensure the Rudder stays
perpendicular to the Elevator (Illustration 17).
7. Your tail assembly is complete!