Manualshelf

FT Tiny Trainer Assembly Guide

ManualsBrandsFlite Test ManualsAirplanesMighty Mini Tiny Trainer Speed Build Electric Airplane Kit (940mm)
11121314151617181920
16
THE BUILD FUSELAGE
REMOVE EXCESS FOAM FROM ELEVATOR
1. Place your Steel Ruler along the etch line of your Elevator.
2. Pull the triangular side (the stabilizer) upward to break the foam free
(Illustration 11).
3. Fold the other side (the Elevator) over, and use your Large Knife to cut a Bevel
at a 45° angle (Illustration 12).
4. Be sure to cut parallel to your body, and keep your thumb and fingers away
from the blade. It is best to cut the Bevel while holding the foam piece on the
edge of a flat surface (Illustration 13).
5. The Elevator side should be able to move freely in both directions. If it doesn’t,
cut a little more from the Bevel.