User Guide

Accessing the CB-3102 via a Web Browser
58
Ariel CB-3102 User and Installation Guide
January 14, 2019
6.3.1.5.4 Motion
The Events Source > Motion screen is used for defining the motion zone area settings; defining
settings, including the method for storing a snapshot, recording on the edge, email headers, and text for
the OSD; and for setting the arming schedule.
Figure 72: Events Source > Motion Screen
Note:
If the camera is attached to Latitude, motion detection configuration should be done from Latitude
Admin Center, not from the web interface.
To enable motion settings
1. Click Enable. By default, Enable is not checked.
2. Click Save Area.
To configure motion zone area settings
1. From the Sensitivity drop-down list, select High, Medium, or Low. The camera reacts to slight
changes in motion or brightness in the motion zone when set to High, while the camera reacts to
big changes in brightness or motion when set to Low.
To define the method to store a snapshot
1. See instructions in section 6.3.1.5.1.
To record the event on the camera
1. See instructions in section 6.3.1.5.1
To enable sending an email notification
1. See instructions in section 6.3.1.5.1.
To define OSD text
1. See instructions in section 6.3.1.5.1.
To set the arming schedule
1. See instructions in section 6.3.1.5.1.