Manual

Advanced Menu3

3. Move the control stick ↑ / ↓ to select MODE, then ← / → to select one of the following

modes:

• EXT: Day / night switch is determined by CdS light sensor. This setting is recom-

mended for cameras that use IR LEDs.

• AUTO: Day / night switch is determined by the camera sensor based on lighting

conditions. This setting is recommended for cameras without IR LEDs.

• COLOR: Camera image remains in color. No nighttime switch will occur in this

mode.

• B&W: Camera image remains in black & white. No daytime switch will occur in this

mode.

4. Select DELAY, then move the control stick ← / → to set the time in seconds it takes for

the camera to switch between day and night modes. For example, setting a DELAY val-

ue of zero means the switch will happen instantly when the proper light level is

detected.

NOTE

DELAY cannot be configured if the MODE is set to COLOR or B&W.

5. If the Day & Night MODE is set to AUTO, configure the D→N LEVEL and N→D LEVEL

to configure day and night switchover levels.

• D→N LEVEL determines the threshold for the switchover from day to night.

• N→D LEVEL determines the threshold for the switchover from night to day.

3.4.2 Smart IR

Enabling Smart IR improves close-up recognition in low light conditions.

To configure Smart IR:

1. From the main menu, use the control stick to select ADVANCED. Push the middle of

the control stick to confirm.

2. Move the control stick ↑ / ↓ to select DAY&NIGHT. Push the middle of the control stick

to confirm.

#LX400044; r. 2.0/22410/22410; en-US